1. The sterilization box should be installed in a special room with a ventilation device with a room temperature above 10 ℃, and smoking and open flames are strictly prohibited. It is not suitable for installation and storage in the basement, and it is not easy to spread and discharge in the event of leakage.

2. The power supply is a dedicated line, the power supply is not shared with others, and there is a reliable ground wire.

3. There are two ways to discharge the residual gas. One is that there is a need to have an upper and lower water device, and the gas decomposition box in the equipment is used to decompose the gas into water and discharge it into the floor drain.

4. The second is to directly discharge the residual gas into the atmosphere, insert the humidification water inlet into the bucket with a pipe link (applicable to electric heating), and be careful not to run out of water. The residual air outlet and the PU pipe are firmly connected, pay attention to sealing. The other end is introduced to the outside of the room and directly connected to the atmosphere. There should be no fire source within 7 meters of the air outlet and good ventilation. Note that the rainproof air outlet has an elbow facing down.

5. The water inlet needs an external water source. The minimum standard of water source is tap water. Soft water is recommended. And the water pressure is not less than 2 kg. The device will automatically enter the water when it is turned on!
EO sterilizer, 2-120 cubic, any need please email to info01@cnoilmachine.com